The list of components i’ve compiled is as follows:

-A corsair 4000D airflow case -Ryzen 5 3600 (might be a slight bottleneck, but i have a 3900X, which is basically the same but double the cores and it barely gets any load during gaming) -BeQuiet Pure Rock 2 cooler -Corsair Vengeance LPX DDR4 2x8gb 3600mhz -BeQuiet System Power 9 CM 600W -ASUS Prime B550-M A -3060 TI, manufacturer doesn’t really matter -2TB M.2 PCIe 4.0 SSD (haven’t decided on a manufacturer yet, but likely to be crucial, corsair or WD)

for context, she’s going to be using a 1440p 144hz monitor and she’s planning to play games like Warzone or some of the newer CoD games

i have built multiple PCs roughly in this region of performance before, and they’ve run great so far.

appreciate any suggestions!

  • TheAlbatross
    2·
    1 year ago

    Double check that the case has enough room for the AIO cooler in the position you want to place it. You can usually find out by checking the manual, companies like Corsair and Fractal Design make a point of mentioning the distances between, say, the top fan mounts and the RAM slots on the motherboard. I ran into an issue with my current build where the RAM I bought is slightly too high and I can’t fit the radiator where I wanted it with the fans attached.

    That said, I put the AIO cooler in the front instead of the top and it runs just fine, even if it’s not as thermally efficient. But it would have saved me some time and frustration during the build to have planned better.

    • KptnAutismus@lemmy.worldOP
      2·
      1 year ago

      this is going to be a regular air cooled system unless i spelled the name of the cooler wrong. thanks for the concern though. vengeance lpx is a very low profile kind of RAM. i never had any issues with an even bigger Beqiet cooler. gonna check the clearance between glass and cooler though.

      • TheAlbatross
        2·
        1 year ago

        Duhhh whoops, I shoulda read a little slower.

        I have one of BeQuiet!'s AIO coolers, hence my warning. Far less likely of an issue with an air cooled system, though I did once run into an issue with a massive cooler knocking against the optical drive cage in an older build (back when optical drives were necessary and GPUs connected via the AGP slot).