• TheFriar@lemm.ee
    link
    fedilink
    arrow-up
    5
    ·
    4 months ago

    I’m no grenade expert, but don’t you need to go squeeze that bar down before pulling the pin out? I always assumed that’s how the mechanics worked

    • Tyfud@lemmy.world
      link
      fedilink
      arrow-up
      5
      ·
      4 months ago

      The pin holds a thing called the “spoon” in place. It’s secured with a hole in either side of it as it attaches to the “neck” of the grenade where the pin going through it secures the spoon to the neck of the grenade.

      When the pin is removed, the spoon is free to come away from the grenade. Usually this takes more than gravity, but not “too” much more. Sometimes the force of removing the pin is enough to rattle the spoon loose/off from the grenade neck, triggering the fuse, in the case of most frag grenades like the one pictured above, the fuse length is pre-cut to be around 4 seconds, until it reaches the payload of TNT at the core of the fragmentation casing, exploding.

      • TheFriar@lemm.ee
        link
        fedilink
        arrow-up
        2
        ·
        4 months ago

        So if you squeeze the spoon to the body of the grenade and pull the pin, the countdown doesn’t start until after you throw it, correct? When the spoon comes off, those four seconds are roughly the amount of time it has to reach where it was thrown?

    • megopie
      link
      fedilink
      English
      arrow-up
      1
      ·
      4 months ago

      Depends on the grenade. Lotta people who talk about “grenade no work like that” are talking about a specific type of grenade they are familiar with.

      Some grenades have very easy pins to pull, some grenades start the fuse as soon as the the pin is pulled, some require the spoon be depressed for the pin to be pulled.

      Reality is, there are many types of grenades that work in different ways.