I have some Fiberology PA12+CF15 blend (link) from a long time ago and recently got around to using it. I am amazed to say the least! It prints easier than PETG, even without an enclosure. Only downside is that it is much more expensive per kg, although it is lower density so I don’t seem to be going through it as quickly as other filaments.

I recently purchased some PC Blend with CF from Prusa as well. I haven’t gotten to print it yet, but I’ve heard very good things about it, too.

What less common filaments do you fine folks like using?

  • Z_Karma@lemmy.world
    link
    fedilink
    English
    arrow-up
    2
    ·
    1 year ago

    I dusted off a sealed roll of polymaker natural ASA for my CR10 V2 pro, trying to print parts for my motorcycle and cars that were previously printed in PLA+. So far a few large parts have warped about 2/3rds of the way through. I purchased a PEI magnetic bed and am now using an enclosure. The benchy i printed looks perfect tho. If i can get it dialed in, i think it will be my favorite.

    • Overzeetop@lemmy.world
      link
      fedilink
      English
      arrow-up
      4
      ·
      1 year ago

      I love ASA for exterior fixes around the house. Durable, stable, but - as you’ve found - a bit finnicky about warping.

    • j4k3@lemmy.worldM
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      If you still have trouble with ASA, get a large trash bag and place everything inside it upside down. The bag will definitely seal everything inside.

      • Z_Karma@lemmy.world
        link
        fedilink
        English
        arrow-up
        2
        ·
        1 year ago

        Now that’s a fantastic budget idea, thank you. I may try exactly that on my smaller printer. I have my CR10 in a comgrow enclosure now and it’s currently 7.5hrs into a 12hr print and it seems to be adhering better to the new PEI bed. Fingers crossed.