SymbioteSynapse

I’m starting to think this guy isn’t a principal.

Just change your view to desktop viewer.

Depends where you live. I live in a desert so humidity isn’t an issue, but dust is. I keep most of my filament in bags just to protect from dust. The only one I actually vacuum seal is tpu. Pla, pla+, and petg all do fine without. If I store it for more than a year though, I run it through the dryer first. Or at least have the dryer running while I print from it.

Try an air fryer. Makes the outside crunchy which I thought would be weird at first, but it’s so much better.

$150k/year. Enough to afford the house I’m in and still have enough left to not have to worry about being short on any recurring bills. Note: I’m in California. Most other states and id be fine at 90-100k.

Its legal to have and use them. Its not required for american cars to have them. That doesnt mean its illegal to have them.

You do if you buy a German car. Even US spec ones have rear fogs.

I loved the darkness games. I really hope they do well with it and get another game out of it in the future. The universe there is so fucking cool & i think they could expand on it so much more.

A remaster of the first one would be amazing though. The 2nd one is on steam and I just replayed that one few months ago. The first one is on xbox 360 and i dont think its even available on the xbox one or pc.

Mine is in my bedroom. Moderate rgb, corsair fans. Light and sound don’t bother me though. It’s quieter than my 3d printer which is also in my room, but I don’t run it at night.

I would have it in another room if I could though. We just don’t have the space right now.

1302.2 hours on DayZ. Havent played since april though. Its a game ill play 30 hours a week until a server reset and then I wont touch it for months.

Destiny 2 and elden ring have been my latest ones though with 469 hours on ER and 365 on destiny 2.

It is against the steam subscriber agreement to use a VPN. Particularly if you’re using it to get around a region restricted game. Will they check and catch you? Probably not, but they can. It’s definately not recommended though.

Make sure you calibrate your e-steps after swapping hotends. I did the same thing on my ender 3 putting on a volcano hotend, and started getting overextrusion. After adjusting the e-steps it was back to normal.

Check for a partial clog. 80% of the time i get that consistency with petg, its because the nozzle is partially clogged. The other 20% is the ptfe tubing is shot. Usually it partially melts and causes underextrusion.

Wet filament could be an issue too, but this is pretty extreme for wet filament.

Jerboa has no ads. Why would i pay $17 a year for removing ads that sync puts on their app themselves? There is nothing that sync is bringing to the table that jerboa doesnt have ad/subscription free.

Halloween Ends (2022)

I watched it in theaters when it came out and really liked it. Interesting slasher movie with good scenes and a good plot. Yes, I wish they would have let Cory keep the spirit of Michael alive, but it is probably better to let the character die in peace.

But then i saw all the Michael Myers fans hating on it afterwards and never understood why. 40% on rotten tomatoes.