

Sofle RBG is also my daily driver. Such a great keeb. I went nuts and fully customized my case and software. I also run box whites, box mute jades, and chosfox arctic foxes. The arctics are my absolute favorite switch. SO tactile and clicky!
Mfg, Nerd, #Entgineer, & #GladScientist, 🛸lifting minds to otherworldly realms with the power of physics 👽 #BecomeABeliever #GoForADryV #SeeTheLight refc-labs.com
Sofle RBG is also my daily driver. Such a great keeb. I went nuts and fully customized my case and software. I also run box whites, box mute jades, and chosfox arctic foxes. The arctics are my absolute favorite switch. SO tactile and clicky!
These were honestly pretty great. So expressive. And usually funny.
I love this, what a cool concept. I always love seeing unique building projects.
That’s just what the defenestrators want you to think
Shitshow doesn’t even begin to describe it
Get used to it. This is only day one. We have a long difficult road ahead of us and less brakes than last time.
Don’t let your memes be dreams
Some mods have CSS/automod set up where if you’re not subscribed, you can’t post. This is actually against reddit’s own TOS, mods are not allowed to break site functionality to gain views, clicks, or participation, but the admins let it slide because it results in higher subscription counts.
“What do you have to say to your advertisers?”
‘go fuck yourselves’
‘also we’re raising prices for an unrelated reason’
The asshole isn’t even in charge yet…
Thanks!
A man of character!
Nope, it’s more important than that… It runs my battestation!
That’s actually pretty damn cool
Am I in someone sane, rational, and smart, like a scientist or humanitarian, or did I wind up as some clueless jackass celebrity? There are wildly different requirements for these.
The latter would probably be easier - but the former would be more resplendent.
If this is new, think you have a wheel adjusted too tight. When this happens, during rest it develops a small flat spot which translates to mechanical ringing in the print. If you let the machine sit for a while, then slowly move that axis, do you feel a bump where it was at rest? All of the axes should be smooth with no felt noise. If you feel noise, you’ll see it in prints.
If not, I would inspect your axis rails for any contaminants or damage, I used one of my printers so much I wore out the actual aluminum extrusion on the y axis and the bed was developing mechanical slop, which was actually difficult to find until I checked the bearing races.
What a gorgeous feline!
It was the concepts of an idea.