My prints come out very well but I’m noticing on larger prints that one corner of my bed prints tighter than the opposite. What’s causing this?

Printing on an Ender 3 Pro with upgraded metal extruder, beefier bed springs and metal levelers, and upgraded hot end. Not direct drive yet and no auto bed leveling.

  • CaptKoala@lemmy.mlEnglish
    2·
    9 months ago

    As someone who’s currently upgrading his setup, I’ve had no luck so far with firmware.

    Can you point to some resources? I’m still a novice and I’m sure I’m not the only one. I’ve done some DDG searching and turned up some hot garbage, maybe I’m looking in all the wrong places?

    • MinorLaceration@lemmy.worldEnglish
      2·
      9 months ago

      Sorry, I’m not able to access my PC for a while so I can’t look. All I did was google something like ender 3v2 bl touch firmware and went from there.

      • CaptKoala@lemmy.mlEnglish
        1·
        9 months ago

        All goods matey, I have yet to do the sensor, I was looking into custom firmwares the other night and found some cool stuff, however my ender refused to accept any updates to it’s standard firmware, so I figured I’d ask here.

    • thegreekgeek@midwest.socialEnglish
      2·
      9 months ago

      I had the same issue myself when I added my bltouch to my CR-10v2. Maybe check YouTube videos for GitHub links? I used the 3dprinting Canada video which had a link to a firmware build that worked.

      • CaptKoala@lemmy.mlEnglish
        1·
        9 months ago

        Appreciate it, I’ll look further into it, a touch sensor is next on the list, be glad to have the knowledge handy when the time comes.