Printed a simple soap tray- it was just a plate printed vertically- 3mm thick with rounded edges.
Prusaslicer settings were 1.5mm fuzzy skin with 2mm connection points, spiral mode with zero bottom infil, and a 3mm brim for adhesion. (The brim is easy to remove, and the edge looks nicer with with no infill.)
100%extrusion width.
not to be that guy… but to me it looks like the gunk-accumulator 3000!
So much cheaper that the gunk accumulators I usually buy
Wash them. But it’s not going to turn moldy (it dries out quickly)