Holy crap, that’s a lot of work to get a roll of filament. That’s only economical if your time is worth nothing. Ugh.

  • Cyborganism@lemmy.ca
    link
    fedilink
    English
    arrow-up
    8
    ·
    1 year ago

    Someone at McGill university figured out how to recycle wind turbine blades into 3d printer filament. However, a single blade made enough filament that it’s length could go to the moon and back. From one blade!

        • sj_zero@lotide.fbxl.net
          link
          fedilink
          arrow-up
          6
          ·
          1 year ago

          Post: “My hot end is only reaching earth’s mantle. Do I need to reach the surface of the sun to make this work?”

        • FuglyDuck@lemmy.world
          link
          fedilink
          English
          arrow-up
          3
          ·
          edit-2
          1 year ago

          Not to be like that… but… gases would be hard to print, I’m not sure why you’d want to….

          Liquids could be interesting, for like, ice sculptures. But at that point you’d be having to extract heat from ambient… drop the build chamber below freezing

            • FuglyDuck@lemmy.world
              link
              fedilink
              English
              arrow-up
              1
              ·
              1 year ago

              Eh. That could work, might be more complicated though.

              I’m envisioning a freezer for an enclosure, then heat the water to just above melting. This would allow using essentially-fdm set ups on the printer itself.

      • Cyborganism@lemmy.ca
        link
        fedilink
        English
        arrow-up
        4
        ·
        1 year ago

        Yes. Well they are mixed with an epoxy.

        You can find the research online with all the details.