Arkansas lawmakers on Thursday voted to audit the purchase of a $19,000 lectern for Gov. Sarah Huckabee Sanders, delving into an unusual controversy that’s prompted questions about the seemingly high cost of the item and claims that the governor’s office violated the state’s open-records law.
The all-Republican executive committee of the Legislative Joint Auditing Committee also voted to audit the Republican governor’s travel and security expenditures that were retroactively shielded from public release under a new Freedom of Information Act exemption Sanders signed last month.
The 39-inch tall (1-meter), blue and wood-paneled lectern was purchased in June with a state credit card for $19,029.25. It has become the focus of intense scrutiny in recent weeks and has gained national attention. The Republican Party of Arkansas reimbursed the state for the purchase on Sept. 14, and Sanders’ office has called the use of a state credit card for the lectern an accounting error. Sanders’ office said it received the lectern in August.
You would never cast iron into a podium, that would be heavy as fuck.
No, it was likely welded and then sanded to a mirror finish, before the horrible powder coat was applied.
And no, that does look like real wood.
It’s ugly as fuck, but I doubt it’s badly built.
Cast aluminum, not iron. And people have gone to dumber extents. I did, however say it was probably sheet metal with panels on top.
Heavy podiums are actually preferred- they’re less likely to topple over when some fat ass leans on them (see trump, for example,) or move when the gesticulation gets …. Excessively … thumpy.
Further… you know what a veneer is? It’s a thin slice of wood glued on top (and edges.) of course it looks like it’s solid wood.
It’s not.
There’s no real reason to do otherwise- few people will be up close to the podium that the seams would be visible.
There’s absolutely no way it’s carved from a monolithic slab- you can tell by the (terribly) book matched grain in the front panel; and the grain pattern is wonky on its edge, suggesting it’s all veneered over.
The differences in appearance are easily explained by different run in manufacturing, with different powder coat formulation and different veneer but the same build. The most i would go is to say it’s a rebadge job from China (like 90% of the stuff on alibaba and Amazon,)