Oh, I thought the joke was that the hole the customer was complaining about was the hole this pipe was supposed to fit into, and that they were measuring the inner diameter rather than the outer.
The joke is they’re supposed to use the end with the spiky bits to measure the inner diameter of the pipe. It’s even more baffling they’re using a mechanical readout when a digital display would be easier to measure with IMO.
I use calipers frequently and didn’t realize it was upsidedown until reading this.
I thought it was a joke about clients always sending shitty low resolution pictures where you can’t actually verify their claim.
Oh, I thought the joke was that the hole the customer was complaining about was the hole this pipe was supposed to fit into, and that they were measuring the inner diameter rather than the outer.
The joke is they’re supposed to use the end with the spiky bits to measure the inner diameter of the pipe. It’s even more baffling they’re using a mechanical readout when a digital display would be easier to measure with IMO.