I have been trying for many hours now to print this circular model, but have been running into inconsistent extrusion and stringing. just before printing this, I successfully printed a set of Hextraction tiles, so I’m not really sure what the issue is. I also printed this model successfully in the past with the same settings.

I am using a Sovol SV06 with stock firmware, and PLA with the hotend at 195° C.

I also did a full calibration to see if that would fix the issue, and it did not.

  • damium@programming.devEnglish
    8·
    2 months ago

    It looks like underextrusion at speed. It might be a clog or you might want to try a higher hotend temperature. PLA can have inconsistent ideal temperatures even with the same brand due to different colors and additives between batches and 185 is on the low side.

    • Interstellar_1OPEnglish
      2·
      2 months ago

      That was a typo it was actually 195, but still thanks this worked!