I’m just starting to get back into growing mushrooms and have a few Oyster blocks ready to fruit. Problem is the temperature in my house/grow tent is usually in the high 70’s or low 80’s (f), and the humidity is in the 30% range. I figured a swamp cooler could help with both of these problems.

I’ve made DIY swamp coolers using a 5 gallon bucket in the past, and I nearly did that again this time, but I’m trying to learn CAD so I decided to try and make something and print it instead of DIYing a 5 gallon bucket. Besides the fact that the integrated tubing inside the print is basically impossible to clean it is working well!

Here’s the humidity and temperature graph over an hour after turning on the device.

  • Skelectus@suppo.fiEnglish
    3·
    1 year ago

    You can also embed pictures straight into the post instead of relying on sites like imgur.

    Interested to see how a 3D printed swamp cooler lasts.

    • Zetta@mander.xyzOPEnglish
      3·
      1 year ago

      Thanks for the tip! I’ve edited the main post.

      Honestly I think it’ll probably hold up fine, I’m using tap water so I think the biggest problem will be mineral build up over time (I live in a pretty hard water area).

    • Zetta@mander.xyzOPEnglish
      1·
      1 year ago

      I definitely will upload it to printables at some point. There are a number of things I want to change and try to improve before I publish it though.

      I’ll make another post when I do!