• fubarx@lemmy.ml
    link
    fedilink
    arrow-up
    6
    ·
    4 months ago

    How you solder those without dropping a blob and causing a short is a mystery.

    • remotelove@lemmy.ca
      link
      fedilink
      arrow-up
      2
      ·
      edit-2
      4 months ago

      Tin the wire and the pin first and then touch the iron to them both quickly. They should stick fairly well without needing to add additional solder. Also, like someone else mentioned, flux can help quite a bit. (Maybe even a cupped soldering iron tip might be useful, depending on the situation.)

      Learning how to solder SMD components will get you extremely familiar with how solder behaves at that scale. Let’s just say it’s significantly different than just doing basic wires and THT.

      (Well, the solder doesn’t really act different, but at smaller scales it looks like it does.)

      • fubarx@lemmy.ml
        link
        fedilink
        arrow-up
        2
        ·
        4 months ago

        I tried to hand-solder a Hirose .35-pitch connector onto a custom OSHPark board once. Let’s just say it was a humbling experience. Thanks to a generous friend, I learned the value of solder masks and owning a home reflow oven.

        Respect to whoever can do this sort of thing, but life is too damn short and my eyesight and hands don’t need the abuse.