Basic blender went bad (motor ran but spindle wasn’t rotating). I wanted to disassemble to see if it could be repaired. Three of the four screws were Phillips head. I had to cut the casing open in order to discover why I couldn’t unscrew the fourth. It was a slotted spanner.
What brand?
deleted by creator
All of them.
Kenmore
Can less
Barbieless
There is a screwdriver that you can get at the hardware store for this type of screw. You shouldn’t have to, I definitely agree. But fuck ‘em, repair your shit with the $5 screwdriver.
Comon, do some reading:
They didn’t have to cut shit.
You are quite spammy, aren’t you?
No, the shaft was not uncovered as a result of cutting the thing open. They were able to reach the screw-head with a regular screw-driver, just not turn it. Says right there in the post.
Learn to read, stop spamming people with your shit takes, and sure, let’s pretend replying to your copy-pasted bullshit with more copy-pasted bullshit is somehow worse. Anything to feed trolls like you.
Which was discovered AS RESULT of cutting open.
You are quite spammy, aren’t you?
No, the shaft was not uncovered as a result of cutting the thing open. They were able to reach the screw-head with a regular screw-driver, just not turn it. Says right there in the post.
Learn to read, stop spamming people with your shit takes, and sure, let’s pretend replying to your copy-pasted bullshit with more copy-pasted bullshit is somehow worse. Anything to feed trolls like you.