The test prints in the image use the 0.2mm detail mode and 0.07mm ultradetail mode

I recently got a SV06, my first 3D printer, about a month and a half ago. About a week ago I started to find really bad oozing/ stringing on all of my prints, to the point that any functional prints are basically unusable. So far what I have tried is:

  • Cleaning the nozzle, inside and out, using a damp cloth and the metal needle tool that came with the printer.
  • Drying the filament. I had two rolls that I was using for the current print, so I used a DIY Dryer to dry both rolls, each on 70 degrees celcius for 4+ hours.

Neither of these have worked. What should I do next?