I’m currently working on a more complex project that uses double sided assembly (and a weird USB-C connector). To practice these things a little, I ordered some low cost boards to get used to that connector and explore double sided reflow (which seems easier than I expected).

For those who are interested, this is a reference design from framework computer for their expansion card system. It can be programmed with circuitpython or Arduino and utilises a SAMD21 microcontroller.

    • tbe@lemmy.worldOP
      link
      fedilink
      English
      arrow-up
      4
      ·
      edit-2
      1 year ago

      Yeah I have such a small, cheap Chinese one (T962) that I modified and flashed a nicer firmware on.

      I basically populated the bottom side (with more components) first after applying solder past with a stencil, then reflowed the board. After cooling down I applied the solder paste to the upper side (with the LED) by using a small needle on a syringe (because using a stencil was too weird since the board wasn’t laying flat) but since the pads are relatively large and not that many that worked fine. Then I placed the components on that side and simply run the reflow cycle again.

      I started with the bottom side because there are no heavy components. I expected heavy parts to just fall off on the second reflow cycle so I tried to avoid that.

      At the end I manually assembled the USB connector using a regular soldering iron and tons of flux gel.

      • teri@discuss.tchncs.de
        link
        fedilink
        English
        arrow-up
        2
        ·
        1 year ago

        Nice! Thanks for explanation! I don’t have much experience with soldering larger circuits. Usually I’m stuck with a soldering iron and tweezers. Just recently got a used stereo microscope. That already helps a lot. But certain packages like BGA are out of reach this way.

        • tbe@lemmy.worldOP
          link
          fedilink
          English
          arrow-up
          1
          ·
          1 year ago

          I was kind of afraid of SMD things in general a long time but I discovered they are (up to a certain size, 0603 is still okay for hand assembly if you’re patient) comfortable to work with. Even QFN packages are okay if you have access to a hot-air station. I did actually order an BGA sensor out of curiosity along with other things, looked at it and was like “hahaha, thanks, I probably better don’t design that thing into my circuit” (I think it’s a 5-WLCSP package).

      • CircuitGuy@lemmy.world
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        I used a Chinese oven that looked just like that, maybe the same model. I found it uneven in its heating, so much so that paste near the door sometimes didn’t flow. It was possibly a step up from my Black and Decker toaster oven.

        • tbe@lemmy.worldOP
          link
          fedilink
          English
          arrow-up
          2
          ·
          edit-2
          1 year ago

          Mine is the smallest one of a series of these, it has two heating elements inside.

          I don’t have it for that long but I didn’t have problems so far, I’m usually only making rather small PCBs tho. I did make some recommended modifications like replacing the paper insulation tape with a kapton tape, proper grounding and flashed another firmware.

          I did only use a small hotplate and/or a hotair station, so it seems to be definitely a stepup here 😌.

  • ColKoala@lemmy.world
    link
    fedilink
    English
    arrow-up
    2
    ·
    1 year ago

    Love the idea of using a USB C connector on a double sided board so you can use it with either side up.