I just installed EndeavorOS on an HP Spectre360 that’s roughly 2 years old. I am honestly surprised at how easy it went. If you google it, you’ll get a lot of “lol good luck installing linux on that” type posts - so I was ready for a battle.

Turned off secure boot and tpm. Booted off a usb stick. Live environment, check. Start installer and wipe drive. Few minutes later I’m in. Ok let’s find out what’s not working…

WiFi check. Bluetooth check. Sound check (although a little quiet). Keyboard check. Screen resolution check. Hibernates correctly? Check. WTF I can’t believe this all works out the box. The touchscreen? Check. The stylus pen check. Flipping the screen over to a tablet check. Jesus H.

Ok, everything just works. Huh. Who’d have thunk?

Install programs, log into accounts, jeez this laptop is snappier than on windows. Make things pretty for my wife and install some fun games and stuff.

Finished. Ez. Why did I wait so long? Google was wrong - it was cake.

  • Gormadt
    44·
    6 months ago

    And sometimes the Windows only software is more “Windows only” and works with Wine

    Windows 3D Builder though is firmly in the Windows Only category though. Which is a bummer because in my experience it’s the best at repairing 3D models for 3D printing that have errors like holes, redundant geometry, inverted faces, etc.

      • Gormadt
        15·
        6 months ago

        I didn’t know about the 16-bit support, which is really cool to say the least

        I see myself as still somewhat of a noob to Linux

      • Gormadt
        6·
        6 months ago

        Lychee Slicer (slicer used for resin printing) is usually pretty good but sometimes it’ll still fail

        Which basically means I’d have 2 choices, go in there manually with Blender or fire up Windows 3D Builder and let it work it’s magic

        I haven’t fully given up on trying to find a way to get it to work on Linux but I’ve had to take a break from trying purely due to frustration