• Norah - She/They
    link
    fedilink
    English
    arrow-up
    7
    ·
    1 year ago

    I don’t think it’s so much the charge circuitry as keeping the battery at 100% all of the time. keeping it plugged, but software limited to 80% capacity is probably better than letting it discharge.

    • misophist@lemmy.world
      link
      fedilink
      arrow-up
      6
      ·
      1 year ago

      I know keeping a battery at 100% is worse than 80% for li-ion batteries. That is not the discussion. OP specifically suggested a constant full charge/discharge cycle as an improvement over leaving the device plugged in, and I can’t imagine that being better for the battery.

      • Norah - She/They
        link
        fedilink
        English
        arrow-up
        2
        ·
        1 year ago

        I guess what I was trying to say is that yeah, it probably would be better than keeping it fully charged. I wouldn’t let it dip below 20% though.

        • Eheran@lemmy.world
          link
          fedilink
          arrow-up
          1
          ·
          1 year ago

          Lower is no problem. The damage is done by the high voltages and also temperature. Don’t go below something like 2 V and you will be just fine.

          • Norah - She/They
            link
            fedilink
            English
            arrow-up
            1
            ·
            1 year ago

            Whilst going below 20% is definitely a lot less bad than going over 80%, it will have the longest life if you stick between those two.

            • Eheran@lemmy.world
              link
              fedilink
              arrow-up
              1
              ·
              1 year ago

              No. Going as low as possible and staying as low as possible is the best for any lithium battery. Here a good source: Accubattery. Note how “battery University” is not a credible source, despite their name. Maybe they made people believe this in the first place.

              And here a primary source for the most fragile LiPo cells. Look at figure 7. Even down to 1.2 V and the cells still reached 50 cycles until they were at 80 % remaining capacity. Not going below 2 V and it will be just fine.