I’m thinking of taking my dosage of 6mg a day down to 4mg a day so I can stockpile 2mg each day in case of an emergency. Or maybe every other day to stockpile 1mg each day.

I’m worried though about it negatively affecting me mentally, but I also know that if I do run out and don’t have a stockpile, it’ll be much worse.

Or maybe I could ask my doctor to prescribe me extra so I can stockpile without reducing my dosage?

Anyways, what are your thoughts on doing this? I know Erin Reed recently put out an article which mentioned it being done (which is what inspired me to make this post).

  • Lily [she/her, pup/pup's]
    link
    fedilink
    arrow-up
    3
    ·
    edit-2
    10 days ago

    21G is too large for long term repeated drawing, 23G or smaller should be used. additionally you dont need to use different needles for drawing and injecting (despite popular belief. subq is not better than IM or “more fool-proof”, infact subq can be worse for many due to irritation. ideally you would want fixed needle syringes for lowest deadspace, as the vial will last longer.

    it should also be noted vials have a shelf life of 2-4 years, so you arent able to stockpile more than that

    • dandelion
      link
      fedilink
      English
      arrow-up
      4
      ·
      edit-2
      10 days ago

      yes, there are lots of ways to optimize.

      23G sounds good for drawing, and I think that is the more standard recommendation (looks like the /r/TransWiki guide lists 23G and 25G), though I haven’t used it personally.

      Re-using the same needle you drew with to inject with can make the needle a bit more dull and I have found it makes the injection more likely to hurt (apparently I’m not the only one). It is also standard practice to change the needle between drawing and injecting to further reduce chance of infection. I’ve read that plenty of people don’t change needles between drawing and injecting, but I’m not sure I would necessarily advertise this as a good practice, esp. for beginners.

      Part of the reason I suggested subq is because it allows for injecting with a smaller gauge needle like 27G, which is less painful and more accessible to people like me who suffer from needle phobia. That’s part of why I think of it as more foolproof, but also because subq doesn’t require targeting a specific muscle or injecting to the correct depth like IM does.

      I’m not sure about irritation from subq that IM doesn’t cause, so I would love more detail on that. I just would imagine the smaller needle, the shorter length, etc. makes it less irritating than a larger gauge and longer needle.

      You can also buy low deadspace syringes without using a fixed needle, but I find these kinds of optimization less relevant when regularly accruing excess medication and there is incentive to use up old medication before it expires. A vial is like $11 for me, so it is also rather cheap, and the medication waste in that context is not worth overly concerning yourself over.

      It would make more sense for DIY, though, when the medication is more expensive (and supply might be less reliable and more scarce). I have never looked at the extra cost of low deadspace syringes compared to the cost of wasted medication from that deadspace, but even with normal syringes I know people have used bubbles in their doses to leave air in the deadspace and get all the medication (correct dosing becomes a bit tricky in this situation, just have to be mindful that you are measuring your dose accurately).